Step 3:Using a ruler as a guide, take the rounded end of a paper clip (or a ballpoint pen that has run out of the ink) and press along the dotted line on the center of the card.
|
Step 4:Using a ruler as a guide, take the rounded end of a paper clip (or a ballpoint pen that has run out of ink) and press along the dotted lines of all the pop-up pieces.
|
Step 5:Carefully cut out the care following the solid, black lines.
|
Step 6:Carefully cut out the witch and the cauldron following the solid, black lines.
|
Step 7:Bringing the sides towards you with the center moving away, fold the cauldron in half along the center dotted line and crease.
|
Step 8:Take hold of the small triangle at the bottom of the cauldron and fold it back in forth, loosening the fold line.
|
Step 9:Fold back the left and right side of the cauldron along their dotted lines by pinching as shown.
|
Step 10:The cauldron should now look like this. The center of the cauldron is pushed away from you. The sides tabs are pushed back.
|
Step 11:Fold back the small triangle again and apply a small amount of white glue. Pull the small triangle over to the left and aligning the center bottom with the bottom of the front of the cauldron. You'll notice that the whole piece begins to curve. This is good! Cauldrons are curved!
|
Step 15:Release the witch and place her on a flat surface.
|
Step 16:Take a hold of the tab marked "A" and fold it up against the witch's body. Open the tab back up to its original position. Repeat the process with the tab marked "B".
|
Step 17:Take hold of witch's body. Pinch the lower half together while pushing the top half back.
|
Step 21:...and fold it over along its dotted line, pressing firmly to let the glue dry.
|
Step 22:Your witch should now look like this. The lower body is coming towards you, the upper body is going back and the head is coming towards you.
|
Step 23:Apply a small amount of glue to the areas marked "A" and "B" on the card.
|
Step 24:Carefully position the witch over the glued areas. Line up her tabs with the areas marked "A" and "B" and press down. Let the glue dry!
|
Step 25:Apply a small amount of glue to the tab areas for both sides of the cauldron.
|
Step 26:Carefully position the cauldron over the glued areas (make sure the witch's broom stays OUTSIDE of the cauldron). Line up the tabs with the areas...
|